May not be available in all stores. Visit www.lowes.com for more details.
Get it custom cut today for a better fit, light control and privacy.
Vinyl Blinds are a durable and practical window covering solution. LEVOLOR'S room darkening S-slat design delivers the tightest closure to maximize privacy. A great value for your home.
Measure exact distance to the nearest 1/8" between inside surfaces of window frame at the top, middle, and bottom, and use the narrowest width. Do not make any width deductions. For Stock blinds, a 1/2" deduction will be taken on the entire blind.
Measure exact distance to the nearest 1/8" from inside surface at top of window to sill at the left, middle and right and use the longest height. If you prefer blind not to touch sill, deduct 1/4". If there is no sill, measure height to the point where the shade reaches.
Measure exact distance to the nearest 1/8" between the outermost points where the blind is to be placed. For optimal light control, this measurement should extend 3/4" beyond the window opening on each side (or 1-1/2" for the entire width).
Measure exact distance to the nearest 1/8" from where top of the blind will be located to the top of sill. If there is no sill or if blind is to overlap window frame, measure to the point the shade reaches.
|Allow Some Overlap|
|For outside mount applications allow the blind to overlap 1-1/2" to 3" on the sides, top and bottom of the window.
You must add the overlap to your measurement; LEVOLOR does not add width or height for overlap on Outside Mounted blinds.
IMPORTANT: If bound, do not remove binding until the shade is installed in the window.
|Width||Up to 37 in.||37 in. to 72 in.|
|A. Mounting Bracket||2||3|
|B. Bottomrail Endcap||2||2|
|C. Headrail Endcap||2||2|
|D. Hold-down Bracket||2||2|
|E. #5 Screw x 3/4 in.||4||4|
|F. #6 Screw x 1-1/4 in.||5||7|
Remove these parts packed in the headrail. Quantity varies with blind size.
Pre-drill wood frame if necessary
Snap together where applicable.
Tilt slats downward for maximum closure.
IF APPLICABLE: Hold-down brackets
The following are instructions to shorten LEVOLOR Stock vinyl blinds.
Install and lower the blind fully.
Select the slat that is even with the window sill or slightly below it, this will become the new bottom slat of the blind.
Pry all the plugs from the underside of the bottom rail
Pull the excess lift cords through the bottom of the rail.
Cut the lift cord to remove the plugs; save the plugs for later.
Slide the bottom rail out of the cords.
Cut all cords approx. 6 in. below your new bottom slat.
Pull the lift cords free of the slats below.
Remove all the excess slats from below the new bottom slat.
Insert the bottom rail between the ladder cords just below the new bottom slat.
Insert the lift cords back through the hole from the top of the rail.
Remove the pieces of lift cord from the plugs.
Insert the lift cords through the top of the plugs.
Slide the plugs to the bottom rail and tie a knot below them (for the moment, do not insert the plugs into the holes).
Trim the excess ladder cords approximately 2 in. below the bottom rail.
Cut the connector cords on the ladder cords.
Trim away excess lift cord below the knot.
Twist together the ladder cords and slide them into the hole in the bottom rail.
Insert the plugs, securing the ladder cords; make sure to secure the ladder cords in the plug notches.
Finally, install the bottom rail end caps onto the bottom rail.